What’s in the Package
- 1 × Adapter (Lid, Screw Cap with Handle)
- 1 × Straw Top
- 1 × Straw Connector
- 1 × Gravity Ball Straw
Product Description & Key Features
- The intentionally short upper straw tip reaches only the front of your baby’s tongue, encouraging proper tongue lifting and a mature swallowing pattern.
- Tactile sensory bumps on the straw tip guide your baby toward proper lip rounding and closure.
- The spill-free EasyDrink Valve allows smooth, effortless sipping without hard suction or biting, while preventing leaks between sips.
- The 360° Gravity Ball Straw follows the liquid, letting your little one drink comfortably from any angle, even when the bottle is tilted or inverted.
- An extended lower straw fits 240ml, 300ml, and 330ml SofTouch™ Nursing Bottles (PP, PPSU, and T-Ester), as well as the StarTouch™ Cup.
- Attributed with 20% ISCC-certified bio-based polypropylene (mass balance approach)* to reduce reliance on non-renewable virgin plastics and create a more baby-friendly world.
Do not use the StarTouch™ Adapter on glass bottles.
*Applies to the handle, lid, and straw connector only.
How To Clean
Before first use, disassemble the product and clean thoroughly. Then, place all components in boiling water for 5 minutes. This is to ensure hygiene. Always wash your hands with soap before cleaning, sterilizing and feeding.
After each use, wash thoroughly with Pigeon Liquid Cleanser. You may use the SofTouch™ Straw Brush for Gravity Ball Straw to wash the Gravity Ball Straw. Ensure that all parts including areas which may not be visible are thoroughly washed and rinsed to remove any residues.
For more information, please refer to the instruction manual.
How To Sterilize
Sterilization Method: Boiling, Steam, Chemical#, UV^
Be sure to sterilize before every use.
| Part | Material | Heat Resistance |
| Lid, Adapter with Handle, Connector | Biomass Polypropylene (PP) 20%*, Polypropylene (PP) 80% | 120°C |
| Straw Top | Silicone Rubber 100% | 140°C |
| Gravity Ball Straw | Stainless Steel 77%, Silicone Rubber 23% | 110°C |
* For the bottle/cap/hood only. Mass balance approach.
# Chemical Sterilization is possible for all parts except the Gravity Ball Straw.
^ It is recommended to replace the product when it starts to discolour and/or turn cloudy.
Usage & Replacement Tips
- Take extra care if your child is teething, as biting can damage the straw top.
- Replace the Straw Top and Gravity Ball Straw every 2 months, or immediately if you observe any signs of wear, tearing, discoloration, or cloudiness.
Precaution
- Do not sterilize or heat the Gravity Ball Straw in a microwave oven.
- Do not fill the cup with hot or carbonated liquids. Hot liquids can cause burns, and pressure buildup from heat or carbonation can cause liquid to spray or leak from the straw tip.
- Handle components with care after boiling sterilization, as they will be hot; allow them to cool before assembling to avoid burns.
- Remove all oil and grease residue thoroughly before sterilizing to prevent permanent staining.
- Open and close the lid firmly to prevent leaks.




















Reviews
There are no reviews yet.